Pages

Monday, 22 May 2017

Obi Wan Kenobi Lightsaber - Internal chassis Printed

Now that the chassis is printed I'm pretty pleased with the print. There are a few details I will need to change, and now that I have discussed some of the design features with a friend I will tweak them also.



The back channel of the print allows for wiring

The battery clips in nicely to the print and holds it well, just need to tweak the alignment. 

The spark 2 fits, some modification for ease of wiring is needed. 

I will need to drill out part of the grenade section to allow for the the charge port under the rear hole in the clamp section, I might change to a smaller recharge port also.

Already on to the upgrades . . . .